Mitsubishi 3000GT Service Manual page 1087

EXTERIOR - Garnishes and Mouldings
Rear Front
Pressure sensitive
double-sided tape
(7) Wipe off application surface of body with clean cloth
dampened with degreaser (3M ATD Part No. 8906 or
equivalent).
NOTE
After wiping surface, leave surface as it is to volatilize
degreaser.
INSTALLATION SERVICE POINT
Adhesion of Pressure Sensitive Double-sided Tape to Side
Garnish (For Reuse)
(1) Use an infrared lamp or the like to heat the pressure
sensitive double-sided tape to 40 to 60°C (104 to 140°F)
for 5 to 10 minutes.
Caution
Do not overheat the tape until its surface dries to
turn white.
(2) Using a resin spatula or gasket scraper, scrape off the
pressure sensitive double-sided tape.
(3) If the pressure sensitive double-sided tape remains on
the side garnish, repeat steps (1) and (2).
(4) Use cloth moistened with degreaser (3M ATD Part No.
8906 or equivalent) to wipe the side garnish clean.
(5) Scrape old adhesive slightly.
Caution
Do not scrape off all old adhesive.
1
(6) Affix specified pressure sensitive double-sided tape to
the side garnish.
Specified adhesive tape:
3M ATD Part No. 6382 or equivalent
TSB Revision