Mitsubishi 3000GT Service Manual page 663

PROPELLER SHAFT
Mating marks
Mating marks
TSB Revision
DISASSEMBLY SERVICE POINTS
REMOVAL
Put mating marks on the front propeller shaft flange yoke
and the companion flange before removing the front propeller
shaft assembly.
Put mating marks on the companion flange and the center
propeller shaft before removing the companion flange.
First remove the center bearing bracket and then remove
the center bearing using a puller (commercially available).
REMOVAL
Put mating marks on the center propeller shaft, the Lobro
joint assembly and the companion flange before removing
the center propeller shaft assembly.
(1) Remove the Lobro joint boot from the Lobro joint assembly.