Mitsubishi 3000GT Service Manual page 644

AUTOMATIC TRANSAXLE - On-vehicle Service
Transaxle
side
Oil seal lip
(3) Using the special tool, tap the drive shaft oil seal into
the transaxle.
Note in illustration the direction of installation of drive
shaft oil seal.
(4) Apply a coating of the transmission fluid to the lip of
the oil seal.
Transmission
SPEEDOMETER CABLE REPLACEMENT
1. Correctly insert the adapter into the instrument panel,
and fasten the new speedometer cable.
2. Install the grommet so that, as shown in the illustration,
the cable attachment part and the projecting part are
horizontal.
Caution
The cable arrangement should be made so that the
radius of cable bends is 150 mm (5.9 in.) or more.
3. At the transaxle end of the speedometer cable, the key
joint should be inserted into the transaxle, and the nut
should be securely tightened.
Caution
If the cable is not correctly and securely connected,
it may cause incorrect indication by the speedometer,
or abnormal noise. Be sure to connect it correctly.
TSB Revision
fluid: DIA QUEEN ATF SP or equivalent