Mitsubishi 3000GT Service Manual page 724

REAR AXLE cAWD>
MB99081 0 G/
Mating marks
MB990939
MB990939
(1) Make the mating marks to the drive pinion and companion
flange.
NOTE
Mating marks should not be made to the contact surfaces
of companion flange and propeller shaft.
(2) Drive out the drive pinion together with the drive pinion
spacer and drive pinion front shims.
REMOVAL
Pull out the drive pinion rear bearing inner race by using
the special tools.
REMOVAL
Using the special tool, drive out the drive pinion front bearing
from the gear carrier.
REMOVAL
Using the special tool, drive out the drive pinion rear bearing
outer race from the gear carrier.
INSPECTION
Check the companion flange for wear or damage.
l
Check the oil seal for wear or deterioration.
l
Check the bearings for wear or discoloration.
l
Check the gear carrier for cracks.
l
Check the drive pinion and drive gear for wear or cracks.
l
Check the side gears, pinion gears and pinion shaft for
l
wear or damage.
Check the side gear spline for wear or damage.
l
TSB Revision