SERVICE BRAKES
TSB Revision
DIAGNOSTIC FUNCTION
DIAGNOSTIC TROUBLE CODES CHECK
With the Scan Tool
Connect the scan tool to the data link connector, then check
diagnostic trouble codes.
Caution
Always turn the ignition switch to connect or disconnect
the scan tool.
NOTE
Diagnostic trouble code No. 16 can be output when the ABS
system fails because of a battery surge.
With 3he ABS Warning Light
(1) Use the special tool (diagnostic trouble code check
harness) to ground the terminal (1) of the data link
connector.
(2) Take a reading of the diagnostic trouble code from the
flashing of the ABS warning light.
Diagnostic trouble
code No. 24 is output
1.5
lluminated -
Switch OFF
Pause
time:
3 seconds
No diagnostic trouble
code is output
I I
NOTE
(1) Other diagnostic trouble codes also are output as
the same code numbers as when using the scan
(2) Diagnostic trouble code No. 16 can be output when
the ABS system fails because of a battery surge.
0.5
One-digit
Ten-digit
Digit
signal
signal
section:
2 seconds
0.5 seconds
0.5
second: