Mitsubishi 3000GT Service Manual page 1182

Resistor
MB991 530
Body wiring harnes
SRS
Turn the ignition key to the "LOCK" position, disconneci
the negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the bat-
tery cable before doing any further work. The SRS
system is designed to retain enough voltage to deploy
the air bag even after the battery has been discon-
nected. Serious injury may result from unintended
air bag deployment if work is done on the SRS system
immediately after the battery cable is disconnected.
Disconnect the passenger's air bag module connector
from the body wiring harness connector.
Connect the SRS check harness connector (1) to the
(3)
body wiring harness connector.
NOTE
A 3-ohm resistor that corresponds to the resistance oi
the passenger's air bag module (squib) and the wiring
resistance is connected between the terminals of the
connector (1) of the SRS Check Harness.
TSB Revision