Mitsubishi 3000GT Service Manual page 1078

EXTERIOR
When using the
MUT
Removal
Installation
Installation
Grommet
Screw
3. INSPECTION WITH SCAN TOOL
When using the scan tool [multi-use tester (MUT) cup
to 1993 models> or MUT-II <all models>]
Using pseudo vehicle speed input function of the scan tool,
inspection can be made by means of vehicle speed.
Set the scan tool to the data link connector.
(1)
When connecting the scan tool (MUT-II) to a vehicle up
to 1993 model, use the adapter harness supplied together
with the scan tool.
Caution
Turn off the ignition switch beforehand whenever the
scan tool is connected or disconnected.
(2) Turn the ignition switch to "ACC" or "ON".
(3) Place the active aero switch to AUTO 1.
(4) Using the scan tool, increase the vehicle speed to approx.
80 km/h (50 mph) or more to make sure that the active
aero system is placed to the operative condition.
Then decrease the vehicle speed to approx. 50 km/h
(30 mph) or less to confirm that the system returns to
the standard condition.
FRONT BUMPER
REMOVAL AND INSTALLATION OF CLIP WITH
SCREW
Normally, remove the clip with a Phillips screwdriver. If, howev-
er, there is enough space to insert a screwdriver or the like
behind the clip, use the following procedure for ease of work.
1 . R e m o v a l
Using a screwdriver or the like, press the screw from the
inside of the bumper to remove the clip.
2. Installation
With the grommet inserted in the hole, press the screw in.
4
0000233 2
TSB Revision