Mitsubishi 3000GT Service Manual page 1034

42-28
Recommended tool
Make the tool by
Sharpen the edge here
Existing adhesive
Apply primer
Lower portion of moulding
BODY - Window Glass
1. Remove the mouldings.
2. To cut the existing adhesive, make a tool such as the
one shown.
mm
16 in.)
3. Using the tool, scoop out the existing adhesive.
Caution
1. Do not remove existing adhesive more than neces-
2. If the coated surface is damaged, apply paint.
Remove here
4. Cut off the lower portion of a new moulding and install
the moulding temporarily to check that it is seated securely.
5. Apply primer to the moulding.
Caution
Never touch the primer coated surface.
6. Apply adhesive to the illustrated area and install the mould-
ing before it hardens.
7. Scrape away excessive sealant forced out during installa-
tion of the moulding from the glass or body and wipe
the surfaces clean with 3M ATD Part No. 8906 or equiva-
lent.
8. After the work, leave the vehicle as it is until the adhesive
hardens.
TSB Revision
sary.
Be careful not to damage the coated surface.