OPERATION
Refer to P.l3A-137.
TROUBLESHOOTING
Refer to P.l3A-138.
INSPECTION
Using Scan Tool
Function
Item No.
11
Data reading
39
Function
Item No.
Data reading 59
69
<Heated Oxygen Sensor (front, rear)>
Function
Item No.
Data reading 48
MULTIPORT
On-Vehicle Inspection of MFI
FUEL INJECTION - Components
Data display
Check condition
Engine: Warm-up
Sensor
detection
(Make the mixture lean by engine
voltage
speed reduction, and rich by racing)
Engine: Warm-up
(Using the heated oxygen sensor
signal, check the air/fuel mixture ra-
tio, and a so check the condition of
control by the engine control mod-
ule)
Data display 1
Check condition
Transaxle: 2nd gear <M/T>
Sensor
l
L range <A/T>
voltage
Drive with wide open throttle
l
Check condition
Data display
Engine: Warm-up
Heater
condition
TSB Revision
Engine state
Standard value
When sudden
200 mV or lower
deceleration
from 4,000 rpm
When engine is
600 - 1,000 mV
suddenly raced
700 rpm
400 mV or lower
(Idling)
2,000 rpm
Engine state
Standard value
3,500 rpm
Engine state
Standard value
ON
750 rpm (Idle)
5,000 rpm
OFF