Mitsubishi 3000GT Service Manual page 643

AUTOMATIC TRANSAXLE - On-vehicle Service
Manual
control lever
Mounting bolt
Section A-A
Hole in end
lange
L.H. side\
. .
PARK/NEUTRAL POSITION SWITCH AND
CONTROL CABLE ADJUSTMENT
1. Place selector lever in "N" (Neutral) position.
2. Loosen transaxle control cable to manual control coupling
adjusting nut to set cable and lever free.
3. Place manual control lever in "N" (Neutral) position.
4. For adjustment, loosen the park/neutral position switch
body mounting bolt, and turn park/neutral position switch
body so that the end (section A-A in illustration on left)
of manual control lever is aligned with the hole in park/neu-
tral position switch body flange.
5. Tighten the mounting bolts of the park/neutral position
switch body to the specified torque. Be careful at this
Manual
time that the position of the switch body is not changed.
control
lever
Specified torque: lo-12 Nm (7-9 klbs.)
Park/neutral
position
switch body
6. Lightly pull the transaxle control cable in the arrow direc-
tion, and tighten the adjusting nut to the specified torque.
Specified torque: 13 Nm (9 ft.lbs.)
7. Check that the selector lever is in "N" position.
8. Check that it securely operates and functions on the trans-
axle side in the range which corresponds to each position
of the selector lever.
DRIVE SHAFT OIL SEALS REPLACEMENT
(1) Disconnect the drive shaft from the transaxle.
(Refer to GROUP 26 - Drive Shaft.)
(2) Using a flat-tip (-) screwdriver, remove the oil seal.
TSB Revision