REMOVAL AND INSTALLATION
Post-installation Operation
Wheel Alignment Check (Refer to P.34-25.)
l
(Refer to GROUP 36 - On-vehicle Service.)
260-300 Nm
188-217 ft.lbs.
55-6
40-4
200-240 Nm*
145-174 ft.lbs.*
Removal steps
1. Rear brake caliper assembly
2. Rear brake disc
3. Drive shaft to companion flange
mounting bolt and nut
4. Self-locking nut
5. Companion flange
6. Rear axle shaft
7. Parking brake cable end
8. Parking brake cable clamp bolt
9. Rear speed sensor CABS>
10. Rear speed sensor cable and parking
brake cable bands CABS>
11. Dust shield
12. Self-locking nut (upper arm)
REAR SUSPENSION cAWD>
36-43 ft.lbs.
'
8
58 Am
42 ft.lbs.
TSB Revision
Rear Brake Disc Run-out Check
l
(Refer to GROUP 35 - On-vehicle Service.)
9
13. Self-locking nut (lower arm)
14. Assist link or tie rod end mounting
nut
15. Trailing arm 'mounting bolt and nut
16. Stopper (18 in.-wheel equipped
vehicles)
17. Rear shock absorber mounting bolt
18. Trailing arm
NOTE
l
: Indicates parts which should be temporarily tightened, and
then fully tightened with the vehicle on the ground in the
unladen condition.