Mitsubishi 3000GT Service Manual page 677

DISASSEMBLY AND REASSEMBLY cFWD>
Disassembly steps
2. Hub and rotor
Adjustment of wheel bearing starting
l
torque
3. Hub
4. Rotor <Vehicles with ABS>
FRONT AXLE - Hub and Knuckle
4
9 Nm
7
DISASSEMBLY SERVICE POINTS
(1) Attach the special tools to the knuckle and front hub.
(2) Secure the knuckle in a vise.
(3) Tighten the nut of the special tool and
and rotor from the knuckle.
Caution
1. Be sure to use the special tools.
2. If the hub and knuckle are disassembled by
striking them with a hammer, the bearing will be
llLO125
damaged.
WHEEL
(1) Crush the oil seal in two places to that
special tool will be caught on the wheel bearing inner
race.
5. Dust shield
7. Snap ring
9. Knuckle
BEARING REMOVAL
0 0 0 0 0 6 3 0
remove the hub
the tabs of the