CONTINUED FROM PREVIOUS PAGE
I
Replace passenger's air bag module (Re-
fer to P.52575.)
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, erase the diagnostic trouble code memory
from the scan tool and check the SRS warning light operation to verify the system functions
properly. (Refer to TEST 1.)
SDU = SRS Diagnosis Unit
SRS
Reconnect negative terminal of battery.
Use the scan tool (when connecting the scan tool (MUT-II:
to a vehicle up to 1993 model, use the adapter harries:
supplied together).
Caution
Before connecting or disconnecting the scan tool
make sure that the ignition switch is placed at the
OFF position.
Turn the ignition key to the "ON" position, erase the diag.
(3)
Return the ignition key from the "ON" to the "LOCK
(4)
position and then back to the "ON" position.
Caution
Never attempt to measure the circuit resistance of the
air bag module (squib) even if you are using the specified
tester. If the circuit resistance is measured with a tester,
accidental air bag deployment will result in serious person-
al injury.
TSB Revision
CONTINUED FROM P.52B-40