FUEL SUPPLY -
Flare nut
Evaporative emission
Fuel tank pressure
control valve
Rubber hose
and Fuel Tank Pressure Control Valve
INSTALLATION SERVICE POINTS
ASSEMBLY INSTALLATION
Align the three positioning projections of the packing with
the holes in the fuel pump and fuel gauge unit assembly.
Temporarily tighten the flare nut by hand, and then tighten
it to the specified torque, being careful that the high pressure
fuel hose does not become twisted.
Caution
When tightening flare nut, be careful not to bend or twist
line to prevent fuel pump from damage.
INSTALLATION
Install so that the fuel tank pressure control valve is facing
in the direction shown in the illustration.
G
UGE
FUEL
A
COVER I
Before installing the fuel gauge cover, apply the specified
sealant to the rear floor pan.
Specified sealant: 3M ATD Part No. 8509 or equivalent
FUEL TANK PRESSURE CONTROL VALVE
REPLACEMENT
Connect a clean rubber hose to the overfill limiter and check
for operation.
N S
A T
O
T A L L
I
N
I