Mitsubishi 3000GT Service Manual page 855

SERVICE BRAKES
After a test drive, use on-board
tic to check (Refer to P.35-39.).
No diagnostic trouble codes out
normal codes are displayed?
Yes
there stored memory of past diagnostic
trouble code.)
Connector terminal No. layout for
troubleshooting
Terminal No. layout shown on the
special tool connector
No
No on-board diagnostic output
Diagnostic trouble codes are
No
1
Caution
1. When carrying out inspection of the ABS-ECU terminal
voltage and resistance, the special tool (MBgg1356)
should be used.
2. Because the ABS-ECU connector terminal No. layout
for troubleshooting is different from the terminal No.
layout shown on the special tool connector, when
using the special tool for inspecting, take the readings
from the special tool terminal Nos.
Example
ABS-ECU connector terminal
No. for troubleshooting
18
TSB Revision
on-board diagnostic output ter-
minals and the diagnosis check
connector.
Referring to the diagnostic
trouble code check chart
E-l-E-7, make the diagnostic
trouble code reoccur to discov-
er the main cause of intermit-
tent or other trouble.
If trouble does not reappear,
watch vehicle movements un-
til it reappears. (Refer to
Terminal No. shown on the spe-
1