Mitsubishi 3000GT Service Manual page 1099

inspection of operation
Inspection of stop position
EXTERIOR
REMOVAL SERVICE POINT
(A, LIFTGATE UPPER MOULDING REMOVAL
Using a special tool, pry the clip portion to remove the upper
INSTALLATION SERVICE POINT
After assembling the wiper blade to the wiper arm, install
the wiper arm with its tip positioned along the ceramic part,
INSPECTION
WIPER MOTOR CHECK
Check the wiper motor with it mounted on the vehicle and
with its harness connector disconnected.
Wiper Motor Operation
Connect a battery to the wiper motor, as shown, to check
the operation of the wiper motor.
Wiper Motor Stop Position
(1) Operate the wiper motor by the procedure described
above and intermediately disconnect the battery to let
the wiper motor stop.
(2) Reconnect the battery as shown and check that the wiper
motor stops at the automatically-stopped position after
operation.
00002343
WIPER WASHER SWITCH CHECK
(1) Remove switch garnish B from the knee protector.