Mitsubishi 3000GT Service Manual page 795

REAR SUSPENSION <FWD>
Shock Absorber Removal (Refer to P.34-13.)
l
Upper arm removal steps
1. Brake tube clamp bolt
2. Self-locking nut
3. Upper arm mounting bolt and nut
4. Upper arm
Lower arm removal steps
5. Lower arm mounting bolt and
6. Self-locking nut
Lower ami
7.
I
upper nrm, Lower nrm ano
Post-installation Operation
Wheel Alignment Check (Refer to P.34-5.)
l
Shock Absorber Installation (Refer to P.34-13.)
l
140-160 Nm*
Assist
10. Assist link
nut
NOTE
l .
. Indicates parts which should be temporarily tightened, and
then fully tightened with the vehicle on the ground in the
unladen condition.
REMOVAL SERVICE POINT
Using the special tool, disconnect the knuckle from the upper
arm, lower arm, and assist link.
Caution
Be sure to tie the cord of the special tool to a nearby
1.
part.
2. Loosen the nut but do not remove it.
1
4
Nm
0 0 0 0 1 0 3 2
link removal steps
8. Assist link mounting bolt and nut
9. Self-locking nut
I