Mitsubishi 3000GT Service Manual page 794

REAR SUSPENSION eFWD>
Press fit
Press out
Inner sleeve
REMOVAL SERVICE POINT
I
SUSPENSION ASSEMBLY REMOVAL
Support the crossmember with a transmission jack, then
remove the crossmember mounting nut and rear suspension
assembly.
INSPECTION
Check the crossmember for cracks or deformation.
l
Check the bushings for cracks or deterioration.
l
CROSSMEMBER BUSHING REPLACEMENT
(1) Using the special tool, remove and press-fit the bushing.
(2) When press-fitting the bushing, apply soapsuds to it and
position the arrows as shown.
(3) Make sure that the protrusion (dimension A) of the inner
sleeve is up to specification.
Standard value (A) : 8.5-9.5 mm (.33-.37 in.)
Revision
TSB