Mitsubishi 3000GT Service Manual page 433

INTAKE AND EXHAUST - Intake Manifold Plenum <Turbo>
INTAKE MANIFOLD PLENUM <Turbo>
REMOVAL AND INSTALLATION
Post-installation Operation
Accelerator Cable Adjustment
l
(Refer to GROUP 13F - Engine Control.)
Turbocharger O-ring osFooo3
Removal steps
1. Air hose A connection
2. Accelerator cable connection
3. Throttle body assembly
4. Throttle body gasket
5. Air pipe A
6. Vacuum hose connection
7. Brake booster vacuum hose connec-
tion
8. Harness connector
9. Clutch
connection
10. EGR temperature sensor
11. Manifold differential pressure sensor
12. EGR valve <Up to 1995 model for
California and from 1996 model>
18 Nm
booster vacuum
hose
REMOVAL SERVICE POINT
Leaving the water hoses and vacuum hoses in their installed
positions remove from the intake manifold plenum.
TSB Revision
7-9 ft.lbs.
13. EGR valve gasket <Up to 1995 model
for California and from 1996 model>
14. EGR pipe installation bolts
from 1996 model>
15. EGR pipe gasket <Up to 1995 model
for California and from 1996 model>
16. intake manifold plenum stay connection
17. Intake manifold plenum installation
bolts
18. Intake manifold plenum installation
nuts
19. Intake manifold plenum
20. Intake manifold plenum gasket
4-6 Nm
3-4 ft.lbs.
0 0 0 0 4 1 5 0