Mitsubishi 3000GT Service Manual page 750

POWER PLANT
Press fit
Press out
Front
Rear
Bushing A Bushing B
Inner sleeve
MOUNT - Crossmember
INSPECTION
Check the crossmember for cracks or deformation.
l
Check the bushings for cracks or deterioration.
l
Check the right member for cracks or deformation.
l
Check the left member for cracks or deformation.
l
BUSHING A AND B REPLACEMENT
Use the special tool to remove and press in bushings A and
B.
Nut
Base
Washer
Bolt
10120
Press in bushings A and B so that the arrows on their bottom
surfaces may be directed in the crosswise direction (except
those on No. 1 crossmember of FWD vehicles).
Caution
Shifting of the arrow in the direction of rotation shall
be within +5" of the crosswise direction.
Press in bushings A and B so that the projecting amount
of the inner sleeve agrees with the standard value.
Standard value:
No. 1 crossmember
Bushing B 7.5-10.5 mm (.30-.41 in.)
Crossmember
Bushing A 7.2-10.2 mm (.28-.40 in.)
Bushing B 6.5-9.5 mm (.26-.37 in.)
Caution
00002122
When pressing in, apply a solution of soap and water
to the slidina Dart of the bushings, and then press them
in without s%pping one after tile other.
If there is a pause during the pressing operation, the
frictional resistance will prevent installation.
TSB Revision