Mitsubishi 3000GT Service Manual page 1187

TEST 9 WHEN DIAGNOSTIC TROUBLE CODE No. 34 IS DISPLAYED
FUSIBLE LINK Q
(1) Turn the ignition key to the "LOCK" position,
disconnect the negative battery cable and tape
the terminal.
Caution
Wait at least 60 seconds after disconnecting
the battery cable before doing any further
work. The SRS system is designed to retain
enough voltage to deploy the air bag even
Is the SDU lock lever securely locked?
Yes
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, erase the diagnostic trouble code memory
from the scan tool (1992 model) and check the SRS warning light operation to verify the system
functions properly. (Refer to Test 1.)
(2) SDU = SRS Diagnosis Unit
SRS - Troubleshooting
No
TSB Revision
SRS diag&sis unit
View A
To front impact sensor (L.H.)"
or unused terminals**
To front impact sensor (R.H.)*'
or to passenger's airbag module**
To body'wiring
To clock spring
harness (14-pin) s%
NOTE
l
l Up to 1993 models
l
2 From 1994 models
after the battery has been disconnected. Se-
rious injury may result from unintended air
bag deployment if work is done on the SRS
system immediately after the battery cable
is disconnected.
(2) Remove the floor console. (Refer to GROUP
52A - Floor Console.)
Replace the SDU.
(Refer to P.528-71.)