Mitsubishi 3000GT Service Manual page 493

ENGINE AND EMISSION CONTROL - Cruise Control System
Control switch
Control switch
SET ON
Control switch
CANCEL:
ON
TSB Revision
CRUISE CONTROL SETTING CHECK
(1) Switch ON the main switch.
(2) Drive at the desired speed within the range of approximate-
ly 40-145 km/h (25-90 mph)*', 40-200 km/h (25-124
(3) Operate the control switch downward. (SET switch: ON)
(4) Check to be sure that the speed is the desired constant
speed when the switch is released, and also check to
be sure that the CRUISE indicator light (within the com-
bination meter) illuminates.
NOTE
(1) If the vehicle speed decreases to approximately 15
km/h (9 mph) below the set speed, because of climbing
a hill for example, the cruise control will be cancelled.
SPEED-INCREASE SElTING CHECK
(1) Set to the desired speed.
(2) Operate the control switch upward. (RESUME switch:
(3) Check to be sure that acceleration continues while the
switch is held, and that when it is released the constant
speed at the time when it was released becomes the
driving speed.
NOTE
Even if, during acceleration, the vehicle speed reaches
or exceeds the high limit, acceleration will continue, how-
ever, when the switch is released, the set speed ("memo-
speed.
SPEED REDUCTION SETTING CHECK
(1) Set to the desired speed.
(2) Operate the control switch downward. (SET switch: ON)
(3) Check to be sure that deceleration continues while the
switch is held, and that when it is released the constant
speed at the time when it was released becomes the
driving speed.
NOTE
When the vehicle speed reaches the low limit [approxi-
mately 40 km/h (25 mph)] during deceleration, the cruise
control will be cancelled.
CRUISE CONTROL CANCELLATION AND SET SPEED
RESUME CHECK
(1) Set.cruise control.
(2) In the cruising condition of the cruise control mode, check
that when any of the following operations are performed,
the normal drive mode is restored and the vehicle coasts
smoothly.
1) Move the control switch toward you. (CANCEL switch:
2) Depress the brake pedal.
3) Depress the clutch pedal. CM/T>
4) Place the gear selector lever in the N range. <A/T>
17-33