A
Section A
Adhesive Window spacer
64 (2.52)
Section B
27 (1.06)
Section C
Adhesive
mm (in.)
BODY - Liftgate Glass
(6) After application of the adhesive, line up the matchmarks
on the glass and liftgate and force the glass lightly and
evenly for complete fitting.
(7) Remove adhesive from around and on the glass and
body surfaces using a spatula and wipe the surfaces
clean.
(8) After the work (installation of the glass), allow to stand
until the adhesive hardens.
Caution
If an infrared lamp or other means are used for quicker
hardening, keep the surface temperature 60°C (140°F)
or lower.
(9) After about 30 minutes or more following bonding of the
Caution
1. If the vehicle is to be moved, do so gently.
2. When the checking for water leaks, do not squeeze
the hose end.
TSB Revision