Mitsubishi 3000GT Service Manual page 1190

19 or No. 20 terminal of SRS Check
Harness connector (5) and ground?
Reconnect negative terminal of bat-
tery, and turn the ignition key to the
"ON" position.
I lo JTEST 9
tween the No. 19 or 20 terminal
(ground) and the No. 12 terminal of
the SRS Check Harness connector
(ground) and the No. 11 terminal of
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, erase the diagnostic trouble code memory
from the scan tool (1992 model) and check the SRS warning light operation to verify the system
functions properly. (Refer to TEST 1.)
(2) SDU = SRS Diagnosis Unit
SRS
N o
Damagedordisconnectedwiringoffuse
No. 18, or damaged or disconnected
body wiring harness.
Damagedordisconnectedwiringoffuse
No. 11, or damaged or disconnected
TSB Revision
(Refer to P.528-18, 20.)
(1) Turn the ignition key to the "LOCK"
position, disconnect the negative
battery cable and tape the terminal.
repair or replace the body wiring har-
Replace the SDU. (Refer to P.52B-64.)
(1) Turn the ignition key to the "LOCK"
battery cable and tape the terminal.
(2)After waiting at least 30 seconds,