Mitsubishi 3000GT Service Manual page 666

PROPELLER SHAFT
Install these balls first
Rubber
packing
1
TSB Revision
(4) Install the remaining balls in their original positions.
(5) Check that the outer race rotates on the inner race
smoothly.
(6) Apply specified grease to the Lobro joint assembly.
Specified grease:
Repair kit grease [45-55 g (1.59-1.94 oz.)]
(7) Apply quick fix adhesive at three locations illustrated to
prevent displacement of the rubber packing and fix it
to the Lobro joint assembly temporarily.
Specified adhesive:
3M ATD Part No. 8155 or equivalent
(8) Lining up the mating marks on the Lobro joint assembly
and the center propeller shaft and applying the socket
to the inner race of the Lobro joint assembly, install the
Lobro joint assembly to the center propeller shaft.
(9) Using the center propeller shaft bolt, align the bolt holes
of the Lobro joint boot and the Lobro joint assembly and
install the Lobro joint boot to the Lobro joint assembly.