Mitsubishi 3000GT Service Manual page 1257

HEATERS AND MANUAL AIR CONDITIONING
EVAPORATOR
Pre-removal and Post-installation Operation
Battery Removal 'and Installation
l
Compressor oil:
refrigerant>
SUN PAG 56
Removal steps
1. Discharge pipe C and suction hose
B connection
2. O-ring
3. Drain hose
4. Stopper
Glove box
ii
REMOVAL SERVICE POINT
DISCONNECTION
If the hoses or pipes are disconnected, cap the hoses or
pipes with a blank plug to prevent entry of dust, dirt, and
water.
INSTALLATION SERVICE POINT
,A( EVAPORATOR INSTALLATION
If a new evaporator is used, fill it with the specified amount
of compressor oil before installing on the vehicle.
Compressor oil:
FREOL S-83 or SUNISO 5GS <Vehicles R-12 refriger-
ant>
SUN PAG 56 <Vehicles using
Quantity: 60 cm3 (2.0 fl.oz.)
INSPECTION
Check for
l
Check for
l
Check for peeling or cracking of the insulator.
l
TSB Revision
,
6. Glove box outer case assembly
7. Under cover
8. Lower frame
9. A/C control unit <Up to 1995 models>
damage of the evaporator fin part.
damage
or collapse of the drain hose.
9-11 Nm
13 Nm
9 ft.lbs.
00002625