Axle housing
MB990938
MB990931
Axle hou
REAR AXLE cAWD> -
INSTALLATION SERVICE POINTS
With the special tool, press fit the inner bearing onto the
axle housing.
(1) With the special tool, press the oil seal onto the axle
housing with the depression in the oil seal facing upward,
and until it contacts the shoulder on the inside of the
axle housing.
NOTE
When tapping the oil seal in, use a plastic hammer to
lightly tap the top and circumference of the special tool,
press fitting gradually and evenly.
(2) Apply multipurpose grease to the oil seal lip.
Orienting the dust shield as shown in the illustration, and
using the special tool, press fit the dust shield until it contacts
the axle shaft shoulder.
NOTE
When tapping the oil seal in, use a plastic hammer to lightly
tap the top and circumference of the special tool, press fitting
gradually and evenly.
With the special tool, install the dust shield so that the
depression is facing upward.
NOTE
When tapping the oil seal in, use a plastic hammer to lightly
tap the top and circumference of the special tool, press fitting
gradually and evenly.
(1) Apply multipurpose grease around the entire
circumference of the inner side of the outer bearing seal
lip.
(2) Using the special tool, press fit the outer bearing to the
axle shaft so that the bearing seal lip surface is facing
towards the axle shaft flange.
ce
0 0 0 0 1 0 4 3
TSB Revision
Axle Shaft