Diagnostic result indication by voltmeter
Waveform for diagnostic trouble code No. 24
digit
signal
NOTE
Other diagnostic items are also indicated by the voltage waveforms corresponding to the code numbers obtainea
when the scan tool is used.
METHOD OF ERASE THE DIAGNOSTIC TROUBLE CODES
When using the scan tool [Multi-use tester (MUT) cup to 1993 model> or MUT-II <All
models>]
(1) Turn the ignition switch to OFF and then back to ON again.
(2) Erase the diagnostic trouble codes.
(3) Check to be sure that no diagnostic trouble codes exist.
When using the voltmeter
(1) Turn the ignition switch to the OFF.
(2) After disconnecting the battery cable from the battery (-) terminal for 10 seconds or more, reconnect
the cable.
(3) Turn the ignition switch to the ON, and read the diagnostic trouble codes to check that a normal
code is output.
AUTOMATIC TRANSAXLE
delimiter
digit
2 sec.
signal
TSB Revision
Waveform when normal
- -