14-8
1993 models>
<From 1994 models>
ENGINE COOLING
RESISTOR CHECK
(1) Measure the resistance between connector terminals (1)
and (4) of the radiator fan motor.
(2) The resistor is normal if the resistance is within the follow-
0
ing range.
Resistance: 0.29-0.35 Q
J
RESISTOR CHECK
and (3) of the radiator fan motor.
(2) The resistor is normal if the resistance is within the follow-
ing range.
Resistance: 0.29-0.35 Q
THERM0 SENSOR CHECK <Up to. 1993 models>
(1) Immerse the water temperature switch in hot water as
shown.
(2) Change the water temperature and check continuity with
a circuit tester. If it is as specified below, the switch is
functioning correctly.
With continuity
(temperature of
point A)
Without continuity
(temperature of
point B)
0 0 0 0 2 2 2 8
RADIATOR FAN MOTOR RELAY CHECK
(1) Remove radiator fan motor relay from the relay box located
at the right side in the engine compartment.
(2) Check for continuity between the terminals when the bat-
tery power-supply is applied to terminal (2) and terminal
(4) is grounded.
When current
flows
When no current
flows
0 0 0 0 2 2 2 1
TSB Revision
condenser fan
Item
For
87°C (189°F)
or less
Between terminals l-3
Between terminals l-3
Between terminals 2-4
For radiator fan
77°C (171 "F)
or less
Continuity
No continuity
Continuity