Mitsubishi 3000GT Service Manual page 811

REAR SUSPENSION <AWD>
r a i l i n g yzf+lM8j
REAR WHEEL ALIGNMENT CHECK
Standard value: -0"lO' + 30'
To adjust camber, turn the lower arm mounting bolt on the
crossmember side.
Left wheel: Clockwise ((-) camber)
Right wheel: Clockwise ((+) camber)
The difference between the right and left wheels should be
One graduation changes camber by about 12'.
TOE-IN
Standard value: 0.5 + 2.5 mm (.Ol + -09 in.)
To adjust toe, turn the trailing arm mounting bolts on the
crossmember side on both sides the same amount.
NOTE
Left wheel: Clockwise (toe-out)
Right wheel: Clockwise (toe-in)
The difference between right and left wheels should be 3
mm (.12 in.) or less.
One graduation changes toe by about 2 mm (.08 in.).
Caution
1. Adjust the eccentric cam bolt within 90" from the
central position.
2. Adjust camber and toe, in that order, and, if camber
is adjusted, be sure to adjust toe also.
3. Make the adjustments with the 4WS tie rod end discon-
nected from the trailing arm.
4. On vehicles without 4WS, disconnect the assist links
from the trailing arms before adjustment.
TSB Revision