Mitsubishi 3000GT Service Manual page 1252

HEATERS AND MANUAL
AIR CONDITIONING
RESISTOR, AIR CONDITIONING COMPRESSOR LOCK
CONTROLLER
REMOVAL AND INSTALLATION
Removal steps
1. Stopper
2. Glove box outer case assembly
3. Resistor
Resistor, Air Conditioning Compressor
I N S P E C T I O N ,
RESISTOR CHECK
Using a circuit tester, measure the resistance between the
terminals indicated below.
The condition can be considered satisfactory if the value
measured at this time is equivalent to the standard value.
S t a n d a r d v a l u e
Terminals measured
Between terminals (2)-(l)
Between terminals (2)-(4)
Between terminals (2)-(3)
00002624
TSB Revision
4. Under cover
5. AI;oor;pressor lock controller
Standard value Q
Approx. 1.76-2.06
Approx. 1 .lO-1.26
Approx. 0.38-0.44