Mitsubishi 3000GT Service Manual page 638

AUTOMATIC TRANSAXLE - On-vehicle Service
(7) Fit special tool (Outer Wrench) to lock nut.
(8) Tighten lock nut by hand until it contacts piston. Then,
(9) Remove the special tool to secure the piston and torque
LINE PRESSURE ADJUSTMENT
(1) Discharge ATF.
(2) Remove oil pan.
(3) Remove oil filter.
(4) Remove oil temperature sensor.
(6) Turn adjusting screw of regulator valve to obtain the speci-
TSB Revision
Turn Outer Wrench clockwise and Inner Wrench counter-
clockwise to unlock the lock nut from special tool (Inner
Wrench).
Caution
Be sure to apply even torque to the two special tools
when unlocking.
using torque wrench, tighten to specification.
Lock nut: 29 Nm (21 ft.lbs.)
Caution
Use of socket wrench or torque wrench could result
in lock nut being turned with adjust rod.
plug to specification at UR brake pressure take-up port.
in grommet; then, remove valve body assembly.
Caution
Do not let manual valve fall.
fied line pressure (K/D brake pressure).
Standard value: 870-890 kPa (124-127 psi)
change for
Oil pressure
each turn of adjustment screw: 38 kPa (5.4 psi)