Mitsubishi 3000GT Service Manual page 554

CLUTCH - Clutch Cover and Disc
INSTALLATION SERVICE POINTS
(1) Apply a coating of the specified grease to the point of
contact with the fulcrum and the point of contact with
the release bearing.
(2) Apply a coating of the specified grease to the end of
the release cylinder's push rod and to the push rod hole
in the release fork.
Pack the inner surface of the clutch release bearing and
the groove with the specified grease.
(1) Apply a coating of the specified grease to the clutch disc
spline, and then use a brush to rub it in.
Clutch disc
(2) Using the universal clutch disc aligner, position the clutch
disc to the flywheel.
(3) install the clutch cover assembly. Tighten the bolts a little
at a time, working in a diagonal sequence, finally tightening
them to the specified torque.
Clutch cove1
assembly