--
plate
FRONT AXLE
DISASSEMBLY SERVICE POINTS
(1) Using the special tool, remove the inner shaft assembly,
together with the seal plate, from the T.J. case.
NOTE
Press the tool directly against the seal plate. The tool
under oressure will ouncture and deform the seal plate,
and push out the inner shaft underneath.
(2) Use the special tool to remove the inner shaft from the
center bearing bracket.
Use the special tools to remove the center bearing from the
center bearing bracket.
REMOVAL
(1) Wrap vinyl tape around the spline on the T.J. side of
the drive shaft so that the T.J. and B.J. boots are not
damaged when they are removed.
(2) Withdraw the T.J. and B.J. boots from the drive shaft.
REMOVAL
Wipe off grease from the B.J. assembly.
Caution
B.J. assembly cannot be disassembled.
TSB Revision