AUTOMATIC TRANSAXLE
TRANSMISSION FLUID LEVEL CHECK
Refer to GROUP 00 - Maintenance Service.
TRANSMISSION FLUID REPLACEMENT
Refer to GROUP 00 - Maintenance Service.
(1) Remove dust, dirt, and other contaminants completely
(2) Snap off the snap ring and remove K/D servo switch.
(3) Fit claw of special tool into cutout in piston to prevent
(4) Loosen lock nut to immediately before V-groove in adjust
(5) Fit special tool (Outer Wrench) over the lock nut. Turn
(6) Fit torque wrench to special tool (Inner Wrench) and repeat
TSB Revision
from kickdown (K/D) servo cover and surrounding areas.
piston from turning and use adapter to fix the piston into
position.
Caution
1. Do not push piston with the special tool.
2. Secure adapter only hand-tight to L/R brake pres-
sure take-up port and do not apply excessive
torque.
rod (see illustration on left) and tighten special tool (Inner
Wrench) until it contacts lock nut.
Outer Wrench counterclockwise and turn inner cylinder
clockwise to lock the lock nut and special tool (Inner
Wrench).
tightening and loosening cycle two times with a torque
of 10 Nm (7.2 ftlbs.). Then, torque-to 5 Nm (3.6 ftlbs.).
Next, back off special tool (Inner Wrench) 2 to 2'14 turns.