Mitsubishi 3000GT Service Manual page 1018

42-12
Door belt
BODY - On-vehicle Service
FUEL FILLER DOOR ADJUSTMENT
Loosen the fuel filler door mounting screw and adjust the
fuel filler door so that the clearance around the fuel filler
door is even without any height differences.
DOOR ADJUSTMENT
1. Use the special tool to loosen the hinge mounting bolts
on the body side, and then adjust the clearance around
the door so that it is uniform on all sides.
2. If the door is not flush with the body, remove the spring
pin from the door check, use the special tool to loosen
the bolts for mounting the door hinges to the door. Move
the door to adjust the door position along the body surface.
Caution
Attach protection tape to the fender edges where the
hinge is installed.
3. If the door does not open freely, adjust the engagement
of the striker with the door latch by means of the striker
mounting shim and move the striker up and down or
from side to side.
00002233
DOOR WINDOW GLASS ADJUSTMENT
Door belt
(When removing and installing the door window
glass)
1. Remove the door trim and waterproof film. (Refer to
2. Remove the front pillar trim.
3. Remove the drip line weatherstrip.
4. Loosen the bolts and nuts of the following parts.
Glass guide front track
l
Glass guide rear track
l
1
Delta sash
l
Stabilizer inner front
l
Stabilizer inner rear
l
. up stop
Door belt line outer weatherstrip
l
NOTE
Move the window glass down to the lowest position before
removing the delta sash bolt.
TSB Revision