Mitsubishi 3000GT Service Manual page 688

FRONT AXLE
J
MB991172
Inner
shaft
assembly
TSB Revision
Shaft
Use the special tool to hold the inner race of the center bearing
and force the inner shaft into place.
INSTALLATION
(1) Apply multipurpose grease to the inner shaft spline, then
press fit it into the T.J. case.
(2) Using the special tool, press the seal plate into the T.J.
case.
(3) Fill the specified grease furnished in the repair kit to the
T.J. case.
Specified grease:
Repair kit grease 160 g (5.64 oz.)
Caution
1. The grease in the repair kit should be divided
in half for use, respectively, at the joint and inside
the boot.
2. The drive shaft joint uses special grease. Do not
mix old and new or different types of grease.
Set the T.J. boot bands at the specified distance in order
to adjust the amount of air inside the T.J. boot, and then
tighten the T.J boot band securely.
Standard value (A): 85 + 3 mm (3.35 + .12 in.)