Is there continuity between the No. 19
or No. 20 terminal of SRS Check Har-
Reconnect negativi terminal of battery,
and turn the ignition key to the "ON
position.
Is there system voltage between the
No. 19 or 20 terminal (ground) and the
No. 14 terminal and No. 13 terminal of
the SRS Check Harness connector (5)?
Yes
NOTE - IMPORTANT
(1) After repairing the SRS, reconnect the battery cable, and check the SRS warning light operation
to verify the system functions properly. (Refer to TEST 1.)
(2) SDU = SRS Diagnosis Unit
SRS
Bum-out SRS warning light bulbs, or
damaged or disconnected body wiring
harness.
(1) Turn the ignition key to the "LOCK"
position, disconnect the negative
battery cable and tape the terminal.
the body wiring hamess.(Refer to
Replace the SDU. (Refer to R52B-71.)