Mitsubishi 3000GT Service Manual page 1045

MB990449
(3) 7
Section B
mm (in.)
BODY
REMOVAL SERVICE POINTS
Using the special tool, pry up the clipped portions to remove
the liftgate moulding upper and lower.
Remove the same way as the windshield glass. (Refer to
INSTALLATION SERVICE POINT
(1) Affix the window spacer to the specified area of the liftgate
glass.
(2) To replace the liftgate glass with a new one, fit the new
body and the liftgate glass.
(3) Apply a uniform coat of primer to the illustrated areas
of the body and glass making sure it is applied without
breaks or thin spots.
Adhesive:
3M SUPER FAST URETHAN PRIMER 8608 or
equivalent
Caution
1. The primer is used to strengthen bonding power.
Make sure that it covers the surfaces completely.
Note that the primer if applied to thick can cause
loss of' bonding power.
2. Never touch the primer coated surface.
(4) Allow 3 to 30 minutes to dry the primer.
(5) Within 30 minutes of primer application, apply the adhesive
all around the liftgate glass uniformly.
Adhesive:
3M SUPER FAST URETHAN 8609 or equivalent
NOTE
Cutting the nozzle tip of the sealant gun to a V-shape
will help application.
42-39