Mitsubishi 3000GT Service Manual page 716

27-24
B.J. boot band: 20-74 #BJ95
T.J. boot band: 20-75#BJ95
REAR AXLE <AWD>
(4) Secure the boot bands.
Caution
1. The boot bands should be tightened with the drive
shaft at a 0" joint angle.
2. The B.J. boot band and T.J. boot band are identified
by the identification number stamped on the lever.
Install correct ones at correct positions.
ZllK033
(1) Apply the specified grease furnished in the repair kit to
the spider assembly.
Specified grease: Repair kit grease
(2) Install the spider: assembly with the chamfered spline
end first.
1 1 5 6 0
Set the T-J. boot bands at the specified distance in order
to adjust the amount of air inside the T.J. boot, and then
tighten the T.J. boot band securely.
Standard value (A): 85 + 3 mm (3.35 f -12 in.)
INSPECTION
l Check the drive shaft for damage, bending or corrosion.
Check the drive shaft spline part for wear or damage.
l
Check for entry of water and/or foreign material into B.J.
l
Check the spider assembly for roller rotation, wear or
l
corrosion.
Check the groove inside T.J. case for wear or corrosion.
l
Check the boots for deterioration, damage or cracking.
l
TSB Revision