Mitsubishi 3000GT Service Manual page 798

REAR SUSPENSION cFWD>
wrench
Press-fit
Removal
I
REMOVAL SERVICE POINTS
Caution
Replace the rear hub assembly with a new one if the
bearing inner race is left on the spindle when removing
the rear hub assembly.
If the removed rear hub assembly is reinstalled with the
inner race attached on the spindle, it can be caused that
the oil seal lip is pushed in the reverse direction, resulting
in oil leaks or loose mounting.
Using the special tool, remove the knuckle from the lower
arm, upper arm, and assist link.
Caution
1. Be sure to tie the cord of the special tool to a nearby
part.
2. Loosen the nut but do not remove it.
INSTALLATION SERVICE POINT
INSTALLATION
Holding the stabilizer link with a wrench, tighten the self-locking
nut so that the protrusion of the stabilizer link (dimension
A indicated in illustration) is within the standard value.
Standard value (A) : 5-7 mm (.197-.276 in.)
INSPECTION
l Check trailing arm for cracks and deformation.
Check bushing for cracks, deterioration and wear.
l
TRAILING ARM BUSHING REPLACEMENT
Use the special tool to remove and press-fit the bushing.