Mitsubishi 3000GT Service Manual page 495

ENGINE AND EMISSION CONTROL - Cruise Control System
RESUME: ON
ON
1
00002439
(1) Remove the air bag module using the following procedure.
1) Remove the negative terminal of the battery and wait
for more than 60 seconds.
Caution
The capacitor in the SRS diagnosis unit retains
enough voltage to deploy the air bag for a given
period even after disconnection of the battery.
If an operation is performed during that given peri-
od, unintended deployment of the air bag could
result and cause serious injury.
2) Remove the air bag module. To remove the clock
spring connector (squib connector) from the air bag
module, force the lock outward and pry it with a plain
screwdriver as shown at left so that no undue force
will be exerted on the connector when it is removed.
3) The removed air bag module should be stored in
a clean, dry, flat place with the pad side up.
(2) Disconnect the connector of the control switch and operate
the control switch to measure the resistance between
the individual terminals.
If the readings are as shown below, the control switch
may be considered good.
Switch operation
When switch is not operated
When switch is operated toward you
(CANCEL switch: ON)
When switch is operated upward
(RESUME switch: ON)
When switch is operated downward
Resistance
between
terminals
No continuity
Approx. 0 52
Approx. 820 Q
Approx. 2,700 a