WINDSHIELD AND LIFTGATE GLASS INSTALLATION PROCEDURE
Body side
Body side
Cleaning bonding surface
Cleaning bonding surface
Scoop out existing adhesive to less than 2 mm
Scoop out existing adhesive to less than 2 mm
Applying primer
Apply primer amply on bonding surface and dry
3 minutes or more.
Fitting clips
Fit the liftgate moulding upper and lower clips.
BODY - Window Glass
body
(wire)
When glass
is reused
Cleaning bonding surface
Scoopoutexistingadhesivecompletelyand
clean bonding surface.
Then, dry 3 minutes or more.
Bonding window dam
Apply the window dam to the glass along the reference position inside of the glass periphery.
Applying primer
Apply primer amply on bonding surface and dry 3 minutes or more.
Applying adhesive
Applying uniform coat of adhesive to the inside of glass periphery.
Installation of glass to
Cleaning of attaching
Glass side
When glass
is replaced
Cleaning bonding surface
Clean the bonding surface and dry
3 minutes or more.