Mitsubishi 3000GT Service Manual page 413

THERMOSTAT
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Engine Coolant Draining and Supplying
l
(Refer to GROUP 00 - Maintenance Service.)
Removal steps
1. Air hose A <Turbo>
3. Air intake hose <Non-Turbo>
4. Radiator lower hose connection
5. Water inlet fitting
6. Gasket
7. Thermostat
Air intake hose B
ENGINE COOLING
INSTALLATION SERVICE POINTS
Install the thermostat with its jiggle valve lined up with the
mark on the thermostat housing.
Assemble the air intake hose A with its notches (arrow-marked)
lined up with the A marks on the air intake hoses B and
C. Insert the hoses into the air intake hose A until they are
bottomed.
TSB Revision
14-9