End plug
Sealant
Sealant
STEERING - Power Steerina Gear
(1) Apply the semi-drying sealant to the threaded part of
the end plug.
Specified sealant:
3M ATD Part No. 8663 or equivalent
(2) Secure the threaded portion of the end plug at two places
by using a punch.
0 0 0 0 2 1 7 7
(1) Position rack at its center. With special tool, tighten rack
support cover to 15 Nm (11 ftlbs.).
(2) In neutral position, rotate pinion shaft clockwise one
cover 30"-60" and adjust torque to the standard value.
Standard value: O-6-1.3 Nm (5-11 in.lbs.)
Caution
1. When adjusting, set the standard value at its
highest value.
2. Assure no ratcheting or catching when operating
rack towards the shaft direction.
NOTE
When it cannot be adjusted within the specified return
angle, check rack support cover components or replace.
(3) After adjusting, lock rack support cover with lock nut.
After installing tie rod to rack, fold tab washer end (2 locations)
to tie rod notch.
MB990776
(1) Pack dust shield interior and lip with multipurpose grease.
(2) Apply semi-drying sealant to dust shield.
Specified sealant:
3M ATD Part No. 8663 or equivalent
(3) Using the special tool, press dust shield to tie rod end.
TSB Revision
Box