Setting Disk Lun Re-Key All - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

Setting disk LUN Re-key All

To rekey all disk LUNs on an encryption node, complete these steps:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
2. Select the switch on which to perform a manual re-key from the Encryption Center Devices
FIGURE 70
3. Click Yes.
4. Open the Encryption Target Disk LUNs dialog box to see LUNs being rekeyed and LUNs
5. Select a disk LUN device from the table, then click LUNs.
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
dialog box (Refer to Figure 1
table, then select Switch > Re-Key All from the menu task bar
Selecting the Re-Key All operation
A warning message displays, requesting confirmation to proceed with the rekey operation.
Rekeying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining rekey operations are held in the pending state.
pending.
a. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 1
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar.
The Encryption Targets dialog box displays
The Encryption Targets Disk LUNs dialog box displays
status of the rekey operation.
Rekeying all disk LUNs manually
on page 14).
on page 14).
(Figure
(Figure 70).
43).
(Figure 71).The dialog box lists the
2
103