Set Snmp Notifyfilter; Clear Snmp Notifyfilter - Enterasys D-Series Cli Reference Manual

set snmp notifyfilter

set snmp notifyfilter
Use this command to create an SNMP notify filter configuration. This identifies which
management targets should NOT receive notification messages, which is useful for fine‐tuning the
amount of SNMP traffic generated.
Syntax
set snmp notifyfilter profile subtree oid-or-mibobject [mask mask] [included |
excluded] [volatile | nonvolatile]
Parameters
profile
subtree oid‐or‐
mibobject
mask mask
included |
excluded
volatile |
nonvolatile
Defaults
If not specified, mask is not set.
If not specified, subtree will be included.
If storage type is not specified, nonvolatile (permanent) will be applied.
Mode
Switch command, read‐write.
Usage
See "About SNMP Notify Filters" on page 7‐28 for more information about notify filters.
Example
This example shows how to create an SNMP notify filter called "pilot1" with a MIB subtree ID of
1.3.6:
D2(su)->set snmp notifyfilter pilot1 subtree 1.3.6

clear snmp notifyfilter

Use this command to delete an SNMP notify filter configuration.
Syntax
clear snmp notifyfilter profile subtree oid-or-mibobject
7-34 SNMP Configuration
Specifies an SNMP filter notify name.
Specifies a MIB subtree ID target for the filter.
(Optional) Applies a subtree mask.
(Optional) Specifies that subtree is included or excluded.
(Optional) Specifies a storage type.