Set Snmp Notifyfilter - Enterasys SecureStack B3 Configuration Manual

Example
This example shows how to display SNMP notify filter information. In this case, the notify profile
"pilot1" in subtree 1.3.6 will not receive SNMP notification messages:
B3(su)->show snmp notifyfilter
--- SNMP notifyFilter information ---
Profile
Subtree
Filter type
Storage type
Row status

set snmp notifyfilter

Use this command to create an SNMP notify filter configuration. This identifies which
management targets should NOT receive notification messages, which is useful for fine‐tuning the
amount of SNMP traffic generated.
Syntax
set snmp notifyfilter profile subtree oid-or-mibobject [mask mask] [included |
excluded] [volatile | nonvolatile]
Parameters
profile
subtree oid‐or‐
mibobject
mask mask
included |
excluded
volatile |
nonvolatile
Defaults
If not specified, mask is not set.
If not specified, subtree will be included.
If storage type is not specified, nonvolatile (permanent) will be applied.
Mode
Switch command, read‐write.
Usage
See "About SNMP Notify Filters" on page 6‐28 for more information about notify filters.
Example
This example shows how to create an SNMP notify filter called "pilot1" with a MIB subtree ID of
1.3.6:
B3(su)->set snmp notifyfilter pilot1 subtree 1.3.6
= pilot1
= 1.3.6
= included
= nonVolatile
= active
Specifies an SNMP filter notify name.
Specifies a MIB subtree ID target for the filter.
(Optional) Applies a subtree mask.
(Optional) Specifies that subtree is included or excluded.
(Optional) Specifies a storage type.
set snmp notifyfilter
SecureStack B3 Configuration Guide 6-33