Set Lacp Asyspri; Set Lacp Aadminkey - Enterasys D-Series Cli Reference Manual

set lacp asyspri

Use this command to set the LACP system priority.
Syntax
set lacp asyspri value
Parameters
asyspri
value
Defaults
None.
Mode
Switch command, read‐write.
Usage
LACP uses this value to determine aggregation precedence. If there are two partner devices
competing for the same aggregator, LACP compares the LAG IDs for each grouping of ports. The
LAG with the lower LAG ID is given precedence and will be allowed to use the aggregator.
Example
This example shows how to set the LACP system priority to 1000:
D2(su)->set lacp asyspri 1000

set lacp aadminkey

Use this command to set the administratively assigned key for one or more aggregator ports.
Syntax
set lacp aadminkey port-string value
Parameters
port‐string
value
Defaults
None.
Mode
Switch command, read‐write.
Sets the system priority to be used in creating a LAG (Link Aggregation
Group) ID. Valid values are 0 to 65535.
Specifies a system priority value. Valid values are 0 to 65535, with
precedence given to lower values.
Specifies the LAG port(s) on which to assign an admin key.
Specifies an admin key value to set. Valid values are 0 to 65535. The
default admin key value is 32768.
set lacp asyspri
Enterasys D-Series CLI Reference 6-41