Set Lacp; Show Lacp Output Details - Enterasys D-Series Cli Reference Manual

set lacp

Table 6-11 show lacp Output Details
Output Field
Global Link
Aggregation state
Single Port LAGs
Aggregator
Actor
Partner
System Identifier
System Priority
Admin Key
Oper Key
Attached Ports
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
Syntax
set lacp {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to disable LACP:
D2(su)->set lacp disable
6-40 Port Configuration
What It Displays...
Shows if LACP is enabled or disabled on the switch.
Displays if the single port LAG feature has been enabled on the switch. See
singleportlag" on page 6-44 for more about single port LAG.
LAG port designation. Each D-Series module provides 6 virtual link aggregator ports,
which are designated in the CLI as lag.0.1 through lag.0.6. Once underlying physical
fe
ports (for example, .x.x) are associated with an aggregator port, the resulting Link
Aggregation Group (LAG) is represented with a lag.x.x port designation.
Local device participating in LACP negotiation.
Remote device participating in LACP negotiation.
MAC addresses for actor and partner.
System priority value which determines aggregation precedence. Only one LACP
system priority can be set on a D-Series device, using either the set lacp asyspri
command (page 6-41), or the set port lacp command
Port's assigned key. D-Series devices provide a default admin key value of 32768 for
all LAG ports (lag.0.1 though lag.0.6).
Port's operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator's will be allowed to aggregate.
Underlying physical ports associated with this aggregator.
Disables or enables LACP.
"set lacp
.
(page 6-46)